[. . . ] To prevent short circuits, we recommend that you disconnect the battery's negative terminal and make all electrical connections before installing the unit. Be sure to ground this unit to the car's chassis again after installation. [. . . ] It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 to 8 ). If the maximum power is less than 50 W, change "AMP GAIN" setting to prevent the speakers from being damaged (see page 15 of the INSTRUCTIONS). To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape. DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged. BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car. If any item is missing, consult your JVC IN-CAR ENTERTAINMENT dealer immediately. The leads of the power cord and those of the connector from the car body may be different in color. Connect the colored leads of the power cord in the order specified in the illustration below. Fuse block Porte-fusible To an accessory terminal in the fuse block Vers borne accessoire du porte-fusible To the remote lead of other equipment or power aerial if any (200 mA max. *2 Before checking the operation of this unit prior to installation, this lead must be connected; otherwise, the Power cannot be turned on. Connectez le fil de commande à distance (bleu avec bande blanche) au fil de commande à distance de l'autre appareil de façon qu'il puisse être commandé via cet appareil. Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit. [. . . ] Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit. Disconnect the speakers from this unit, connect them to the amplifier. [. . . ]